Crusher Equipment4721

Description: Analysis of the causes of fracture of the fracturer's bracket
Group News
02/27/2019  
1. Overloading of the main engine: When the Crusher Equipment is in operation, if the operator makes the main engine overload, or the size of the ore is larger than the inlet, etc., both of these conditions will cause the bracket to break. In this case, the bracket should be replaced. Control the granularity of the feed and prevent overloading of the host.
Second, the low strength of the toggle plate: the material of the elbow plate of the equipment is mostly cast by cast steel material with low strength. Because of insufficient strength, it is difficult to reach the crushing force of normal crushing and elbow when encountering non-broken material. Plate breakage.
3. Fracture of the tensioning device: If the tensioning device breaks, the bracket is pulled out from the supporting slider, causing the flywheel to rotate, the crusher does not work, and the toggle plate is broken. Therefore, the fracture should be replaced or repaired in time. Tensioning device.
4. There is no balance between the bracket and the bracket: when the bracket is installed, if the bracket and the bracket are not leveled or skewed, the bracket will be broken, so the bracket is installed and replaced. The brackets should be properly installed.
5. The spring pressure is too large: when the Stone crushing equipment is working, it encounters the spring pressure too tight, so that the bracket has no cushioning force, which causes the bracket to break. When the crusher is working, the tightness of the spring should be checked frequently to prevent the spring pressure from being excessively broken.
Group Messages
There are no messages yet
Group Owner: crushermachine169
Group Type: Open
© 2014 WritingRoom.com, LLC. ALL RIGHTS RESERVED
WRITING | POETRY WRITING | CREATIVE WRITING | WRITE A BOOK | WRITING CONTESTS | WRITING TIPS