Sand Making Machine716

Description: In order to improve the efficiency of the sand production line, pay attention to several aspects
Group News
05/09/2019  
The Sand Making Machine is a production line equipment specially designed for the production of sand and gravel for construction. High degree of automation, low operating cost, high breaking rate, energy saving, large output, less pollution, easy maintenance, and the machine sand produced is in line with national construction sand. Standard, product size is uniform, particle shape is good, and the classification is reasonable. In order to improve the efficiency of the sand production line, pay attention to the following aspects.
First of all, we should understand a problem. The sand making line is a rough breaking device for crushing hard materials such as ore. It has the characteristics of large crushing rate, high output, average particle size, simple structure, convenient maintenance and low production cost. When the sand making line is working, the movable jaws are in direct contact with the material, so the load is usually large. Providing insurance to ensure that this supply will greatly increase the active control of all sand making equipment and production lines. Secondly, we should understand that the more mud or fine particles in the feed of the sand production line, the greater the viscosity of the pulp, the smaller the sedimentation speed of the ore in the pulp, and the coarser the particle size of the overflow. Product; in order to reduce the overflow fineness required to meet the requirements, supplemental water can be appropriately added to reduce the slurry concentration. If the amount of mud in the feed is small, or after decontamination, the slurry concentration should be appropriately modified to reduce excess fines in the return sand.
When the sand making line enters the non-crushing stone in the crushing chamber, the rear thrust plate acts as a safety component of the sand making machine and is used to maintain important parts without damage. The back thrust plate is cast separately from cast iron and has one or more holes in it to reduce the strength of the section; or two parts can be cast and then joined together by screws to form a combined thrust plate. However, when the unbreakable stone and sand enter the fine crushing chamber, the equipment is overloaded, and the thrust plate is transmitted to the thrust plate, causing the thrust plate to rupture or the combination of the thrust plate to deform and cut the screw, and the machine completes the work and plays an insurance role. . This design principle is not only very suitable, but also cumbersome to operate, the use of interchangeable safety parts is low, the operation is arbitrary, and the overall maintenance and equipment are not damaged.
The granulation requirements of the Sand Making Machine are very good. Typically, the needle-like material enters the finely divided nacelle and the requirements for gravel are contrary to the above, and the requirements for particle type and grain size are very strict. The reason is that cubic sand has a function of locking each other due to its angular shape, and continuous grading of sand can greatly reduce voids, while cubic sand occupies a larger outer surface than circular sand. Combine asphalt with materials or cement and materials to reduce the possibility of drainage.
In this regard, users may feel that the loss of the sand production line seems to be more difficult than improving production efficiency, but this is not the case. This is just a matter of literal understanding. As long as we often produce time, we will find that the production line is a sand making device, the working principle is very simple, simpler and more effective than traditional equipment. More benefits for customers.
Group Messages
There are no messages yet
Group Owner: crushermachine169
Group Type: Open
© 2014 WritingRoom.com, LLC. ALL RIGHTS RESERVED
WRITING | POETRY WRITING | CREATIVE WRITING | WRITE A BOOK | WRITING CONTESTS | WRITING TIPS