ultrafine mill39

Description: What are the factors affecting the particle size of the ultra-fine mill?
Group News
For the milling industry, the size, size, and quality of the product of the ultrafine mill equipment determine whether it is the first check of high-quality equipment. The size of the discharge particle size is determined by the processing enterprise when it is purchased. The first judgment is that the discharge granularity of Shanghai SBM ultra-fine mill equipment can be adjusted between 300 and 3000 meshes. So, in some cases, ultrafine mill discharge size is affected by what factors?In the process of ultra-fine mill processing, users should grasp the relationship between various influencing factors, so as to achieve a good production effect. Sometimes the finished particle size does not meet the requirements. At this time, the user must observe and test the production of the finished product and balance the relationship between the factors. In order to control the granularity of the product, the user must strictly grasp the relationship between these factors.Ultra-fine mill fan speed - in production, due to the difference in the size of the feed itself, if the wind is too large, even if the lighter material does not meet the fineness requirements, it will be blown into the powder collector. On the contrary, if the material is large and the wind is too small, the discharge will also be affected. Therefore, fan speed is an important factor in the entire production process.Ultrafine grinding machine - host speed. In the actual production process, it is very important to control the rotation speed of the host machine. If the speed of the main engine is too high or too low, it will have a great impact on the size of the product. Because the speed reducer and the motor of the milling equipment are linked through the accessory shaft of the mill, then we can adjust the speed by adjusting the current of the motor.The wear of the ultrafine mill blades is analyzed. The blades of the analyzer are circularly distributed. During the production, the blades will also wear out over time. The wear will directly cause the analyzer to reduce the selection of powder. With the efficiency, the coarse powder enters into the interior of the powder collector, which affects the size of the discharged material.The abrasion of the grinding roller and the grinding ring of the ultra-fine pulverizer—because the working load of the mill is large and the running time is long, the wear phenomenon easily occurs. The occurrence of wear will result in insufficient grinding of the material, so that the finished particle size cannot achieve the desired effect.In the future production, when the particle size of the ultra-fine pulverizer does not meet the requirements, the above points can be used to start remedy and find the crux of the problem. Ensure the safety of the user's use of the mill and the guarantee of production efficiency. Shanghai SBM will send you any kind of assistance at any time.
Group Messages
There are no messages yet
Group Owner: crushermachine169
Group Type: Open
© 2014 WritingRoom.com, LLC. ALL RIGHTS RESERVED